1. CONSTRUCT THE MINI BAR
Connect the bottom (D) and top (E) sections of the mini bar using the short screws (J). Repeat for both sides.
2. CONSTRUCT THE HIGH BAR
Connect the bottom (F) and top (G) sections of the high bar using the short screws (J). Repeat for both sides.
3. BUILD THE BASE
Connect two triangle plates (I) to the base main (A) using the long screws (K) and attach the angled support (C) to the base using the short screw (J). Repeat for both sides. Note: the indent on the base should face the floor.
4. CONNECT THE BASE
Connect the assembled base mains (A) using two support bars (B) and long screws (K).
5. ATTACH MINI BARS TO BASE
Attach the left and right sides of the assembled mini bars to the base main (A) using the short screws (J).
6. ATTACH HIGH BARS TO BASE
Insert the high bar into the centre of the two triangle plates and secure with two long screws (K). Finish securing the high bar by attaching the angled support bar (C) with a small screw (J).
7. ATTACH SLIDERS
It is important the screws have not been tightened – the uprights should have a small amount of give when attaching the pull-up bars (H). After the two pull-up bars have been installed, tighten all screws.
